Universal Journal of Mechanical Engineering Vol. 7(6B), pp. 6 - 11
DOI: 10.13189/ujme.2019.071502
Reprint (PDF) (228Kb)

Optimization of Pull-Type Production Process with Computer Aided Process Planning

Debrina Puspita Andriani ^1,*, Azizah Putri Nur Aini ¹, Intan Mardiono ², Adam Khano ^1
1 Department of Industrial Engineering, Brawijaya University, Malang, Indonesia
² Department of Industrial Engineering, Institut Teknologi Sumatera, Lampung, Indonesia

ABSTRACT

Pull type is production that is based on actual demand and requires a fast and precise manufacturing process in the system. The conventional method caused consumers‘ frequent dissatisfaction with the results and took long production times and high cost. The purpose of this study was to compare between the application for conventional methods and Computer Aided Process Planning (CAPP) method in pull-type production system. Starting with identifying the problems that exist in the results of observations in the field study, then setting the goal of improving the initial production method. Furthermore, the process was conducted by comparing production time using time study method and breaking even calculation. The results show that CAPP method obtained the reduction in the cost and time production than conventional methods.

KEYWORDS
Computer Aided Process Planning, Generative Management, Optimization, Pull-Type Production, Time Study

Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Debrina Puspita Andriani , Azizah Putri Nur Aini , Intan Mardiono , Adam Khano , "Optimization of Pull-Type Production Process with Computer Aided Process Planning," Universal Journal of Mechanical Engineering, Vol. 7, No. 6B, pp. 6 - 11, 2019. DOI: 10.13189/ujme.2019.071502.

(b). APA Format:
Debrina Puspita Andriani , Azizah Putri Nur Aini , Intan Mardiono , Adam Khano (2019). Optimization of Pull-Type Production Process with Computer Aided Process Planning. Universal Journal of Mechanical Engineering, 7(6B), 6 - 11. DOI: 10.13189/ujme.2019.071502.