Manufacturing Science and Technology(CEASE PUBLICATION) Vol. 3(1), pp. 10 - 15
DOI: 10.13189/mst.2015.030102
Reprint (PDF) (359Kb)

An Overview of Machining Process of Alumina and Alumina Ceramic Composites

Pravin Pawar ^*, Raj Ballav , Amaresh Kumar
Department of Manufacturing Engineering, National Institute of Technology, Jamshedpur, 831014, India

ABSTRACT

The present paper gives a critical review of Alumina and alumina composite ceramic materials machined by different machining process. The article shows that a review on machining of alumina and alumina composites with different input parameters and different output responses such as Material Removal Rate (MRR), Tool Wear Rate (TWR),Surface Roughness(Ra) etc. using a different mechanism of machining technique, SWOT Analysis & its summery results of literature review.

KEYWORDS
Alumina, Material Removal Rate, Tool Wear Rate, Surface Roughness, USM, AWM, EDM, ED Milling, ECDM, SWOT

Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Pravin Pawar , Raj Ballav , Amaresh Kumar , "An Overview of Machining Process of Alumina and Alumina Ceramic Composites," Manufacturing Science and Technology(CEASE PUBLICATION), Vol. 3, No. 1, pp. 10 - 15, 2015. DOI: 10.13189/mst.2015.030102.

(b). APA Format:
Pravin Pawar , Raj Ballav , Amaresh Kumar (2015). An Overview of Machining Process of Alumina and Alumina Ceramic Composites. Manufacturing Science and Technology(CEASE PUBLICATION), 3(1), 10 - 15. DOI: 10.13189/mst.2015.030102.