Journals Information
Universal Journal of Mechanical Engineering Vol. 2(7), pp. 240 - 247
DOI: 10.13189/ujme.2014.020705
Reprint (PDF) (988Kb)
Characterization of Chip Morphology for Aluminum Metal Matrix Composites in End Milling Machining
Akash Rathi , Abhishek Mahor , Rajeev Ranjan , Abhishek Gajbhiye , A. Rehman , C. M. Krishna *
Maulana Azad National Institute of Technology, Bhopal, Madhya Pradesh, India
ABSTRACT
End milling using a solid mill cutter is widely used in aerospace, automotive, biomedical, and chemical industries. However, a comprehensive characterization of chip morphology and micro structural and mechanical behavior of machined chips is lacking in the literature. A series of end milling experiments were conducted for studying the chip morphology of Aluminum metal matrix composite. A new multi-view approach to fully characterize metallurgical aspects of chip& chip morphology including top surface and free surface is taken up in this research paper. Each view of the 3-dimensional (3D) chip has been studied for different characteristics. The variation of chip dimensions with cutting parameters was also determined.
KEYWORDS
Composites, End Milling, High Speed Camera, Chip Dimensions, Regression Modelling
Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Akash Rathi , Abhishek Mahor , Rajeev Ranjan , Abhishek Gajbhiye , A. Rehman , C. M. Krishna , "Characterization of Chip Morphology for Aluminum Metal Matrix Composites in End Milling Machining," Universal Journal of Mechanical Engineering, Vol. 2, No. 7, pp. 240 - 247, 2014. DOI: 10.13189/ujme.2014.020705.
(b). APA Format:
Akash Rathi , Abhishek Mahor , Rajeev Ranjan , Abhishek Gajbhiye , A. Rehman , C. M. Krishna (2014). Characterization of Chip Morphology for Aluminum Metal Matrix Composites in End Milling Machining. Universal Journal of Mechanical Engineering, 2(7), 240 - 247. DOI: 10.13189/ujme.2014.020705.