Civil Engineering and Architecture Vol. 10(7), pp. 3097 - 3109
DOI: 10.13189/cea.2022.100723
Reprint (PDF) (1740Kb)


Improving Efficiency of Earthworks in Hydraulic Engineering Construction


Zhambyl Duisebayev 1,*, Anuarbek Aimen 2, Berikbay Orazaliyev 3, Umirzhan Kokayev 4, Raigul Toxambayeva 1
1 Institute of Water Management and Environmental Management, M.Kh. Dulaty Taraz Regional University, Republic of Kazakhstan
2 Faculty of Technology, M.Kh. Dulaty Taraz Regional University, Republic of Kazakhstan
3 Department of Transport Equipment and Technologies, S. Seifullin Kazakh Agrotechnical University, Republic of Kazakhstan
4 Department of Transport, Transport Equipment and Technologies, L.N. Gumilyov Eurasian National University, Republic of Kazakhstan

ABSTRACT

The purpose of this article is to determine the degree of increase in productivity and efficiency of an excavator equipped with a bucket with a variable cutting-edge shape. The work of excavators with buckets, in which the shape of traditional and cutting blades has changed, was compared. A quantitative picture of maximizing the productivity of the excavator during the development of various soils was determined. The possibility of adapting the cutting edge itself depending on soil conditions was investigated. In addition, the influence of the adaptation of the cutting edge of the bucket on the technical characteristics and mode of operation, power, and energy parameters of the digging process was determined. The obtained results of determining the technical characteristics of the excavator with a different shape of the cutting edge and the contact component of the excavation resistance were compared with the results of buckets of the usual type. Processing of experimental data made it possible to obtain a regression model that determines the factor of dependence of response functions on transforming factors.

KEYWORDS
Earthworks, Hydraulic Engineering, Single-bucket Escalators

Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Zhambyl Duisebayev , Anuarbek Aimen , Berikbay Orazaliyev , Umirzhan Kokayev , Raigul Toxambayeva , "Improving Efficiency of Earthworks in Hydraulic Engineering Construction," Civil Engineering and Architecture, Vol. 10, No. 7, pp. 3097 - 3109, 2022. DOI: 10.13189/cea.2022.100723.

(b). APA Format:
Zhambyl Duisebayev , Anuarbek Aimen , Berikbay Orazaliyev , Umirzhan Kokayev , Raigul Toxambayeva (2022). Improving Efficiency of Earthworks in Hydraulic Engineering Construction. Civil Engineering and Architecture, 10(7), 3097 - 3109. DOI: 10.13189/cea.2022.100723.