Chemical and Materials Engineering(CEASE PUBLICATION) Vol. 2(2), pp. 33 - 36
DOI: 10.13189/cme.2014.020202
Reprint (PDF) (365Kb)

Manufacturing Solution for Producing Cobalt-ferrite Films

Patrusheva T.N. ^1,*, Podorojnyak S.A. ¹, Polyakova K.P. ², Kirik S.D. ³, Menshikov V.V. ⁴, Levchenko S.I. ⁴, Patrushev V.V. ³, Adrianova M.A. ¹, Gerasimova G.E. ^1
1 Siberian Federal University, Krasnoyarsk,660044, Russia
² L.V. Kirensky Institute of Physics SB RAS, Krasnoyarsk, Russia
³ Institute of Chemistry and Chemical Technology SB RAS, Krasnoyarsk, Russia
⁴ Siberian State Technological University, Krasnoyarsk, Russia

ABSTRACT

An extraction-pyrolytic technique and its usage for obtaining pure products from secondary manufacturing solutions are considered in this paper. Nanostructure ferrite thin films were prepared using the extraction-pyrolytic technique. It was shown that the extraction from modeling liquid of waste solution allows obtaining the pure single phase product. Fe₂CoO₄ magnetic films with grain sizes 18–20 nm were obtained by cycling pyrolysis of wet films deposited by the spin coating technique.

KEYWORDS
Composite Oxides, Wet Technique, Extraction, Nanosize Materials, Homogeneity

Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Patrusheva T.N. , Podorojnyak S.A. , Polyakova K.P. , Kirik S.D. , Menshikov V.V. , Levchenko S.I. , Patrushev V.V. , Adrianova M.A. , Gerasimova G.E. , "Manufacturing Solution for Producing Cobalt-ferrite Films," Chemical and Materials Engineering(CEASE PUBLICATION), Vol. 2, No. 2, pp. 33 - 36, 2014. DOI: 10.13189/cme.2014.020202.

(b). APA Format:
Patrusheva T.N. , Podorojnyak S.A. , Polyakova K.P. , Kirik S.D. , Menshikov V.V. , Levchenko S.I. , Patrushev V.V. , Adrianova M.A. , Gerasimova G.E. (2014). Manufacturing Solution for Producing Cobalt-ferrite Films. Chemical and Materials Engineering(CEASE PUBLICATION), 2(2), 33 - 36. DOI: 10.13189/cme.2014.020202.