Civil Engineering and Architecture Vol. 9(2), pp. 404 - 409
DOI: 10.13189/cea.2021.090213
Reprint (PDF) (699Kb)

Experimental Study of Adobe Masonry and its Adherence with Reinforced Concrete Confinement Elements

Jesús A. Velarde Gil L. ¹, María T. Sánchez M. ^2,*, Rubén S. Roux G. ³, José A. Espuna M. ^2
1 Department of Earth Sciences, Technological Institute of Tijuana, Baja California, México
² Faculty of Architecture, Design, and Urbanism, University Autonomous of Tamaulipas, Circuito Universitario S/N, Centro Universitario Sur, Tampico, Tamaulipas, México
³ Tamaulipas Institute of Higher Studies, IEST-ANÁHUAC, Altamira, Tamaulipas, México

ABSTRACT

The constructions with adobe masonry confined with concrete elements, experience a separation between them, mainly due to the inherent physical and chemical characteristics of both materials that are not very compatible with each other; adobe, a raw masonry with a high clay content, undergoes changes in its shape in the presence of humidity and temperature variation, which affects its adherence to concrete elements, compromising the confinement, function and stability of the walls. The different coefficients of expansion and contraction between concrete and adobe, added to their physical properties, make it difficult to achieve adequate adherence between these two materials. In the present study, 6 mixtures of earth (adobe) were designed, with different granulometry proportions to measure the adherence between adobe and concrete, identifying the most suitable one with the purpose of using it as a bonding material in walls for houses, from this study, with the best response being the sample MA-3. The test methodology was based on standards applicable to concrete and annealed brick masonry, as there is no available one for this material. Thirty-six adobe specimens adhered to concrete were tested, to which a normal load was gradually applied to their cross section, to a piece of adobe between two pieces of concrete, recording the ultimate horizontal shear stress between both materials. The scope is considered the result of the test of adobe pieces adhered to concrete subjected to horizontal shear force, considering different granulometry in the composition of the adobe mixture. This work provides a starting point for the standardization of the test and the justification of the need for an additional element that contributes to the confinement.

KEYWORDS
Adobe, Adherence, Concrete, Confined

Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Jesús A. Velarde Gil L. , María T. Sánchez M. , Rubén S. Roux G. , José A. Espuna M. , "Experimental Study of Adobe Masonry and its Adherence with Reinforced Concrete Confinement Elements," Civil Engineering and Architecture, Vol. 9, No. 2, pp. 404 - 409, 2021. DOI: 10.13189/cea.2021.090213.

(b). APA Format:
Jesús A. Velarde Gil L. , María T. Sánchez M. , Rubén S. Roux G. , José A. Espuna M. (2021). Experimental Study of Adobe Masonry and its Adherence with Reinforced Concrete Confinement Elements. Civil Engineering and Architecture, 9(2), 404 - 409. DOI: 10.13189/cea.2021.090213.