Universal Journal of Mechanical Engineering Vol. 2(2), pp. 49 - 54
DOI: 10.13189/ujme.2014.020203
Reprint (PDF) (652Kb)


Investigation of Machinability Tests for Brass Alloy


Hana Pechová 1,*, Václav Koutný 1, Jiří Faltus 2
1 Czech Technical University in Prague, Faculty of Mechanical Engineering, 166 07 Praha 6, Technická 4, Czech Republic, Europe
2 VÚK Panenské Břežany, Panenské Břežany, 25070, Praha – Východ, Czech Republic, Europe

ABSTRACT

The Brasses are copper alloys. The main element is zinc brass. The most widespread are Cu and Zn binary alloys with different contents of zinc. Binary brass make up a relatively large group of copper alloys in which zinc content varies from 2.5 to approximately 49 %. In addition, there brass, which, besides zinc has other elements. These alloying elements give the brass its material properties. According to the zinc content is divided into low, medium and high percentage of zinc brass.

KEYWORDS
Brass, Lathe, Drilling, Constant Yoke Force, Turning, Chips

Cite This Paper in IEEE or APA Citation Styles
(a). IEEE Format:
[1] Hana Pechová , Václav Koutný , Jiří Faltus , "Investigation of Machinability Tests for Brass Alloy," Universal Journal of Mechanical Engineering, Vol. 2, No. 2, pp. 49 - 54, 2014. DOI: 10.13189/ujme.2014.020203.

(b). APA Format:
Hana Pechová , Václav Koutný , Jiří Faltus , (2014). Investigation of Machinability Tests for Brass Alloy. Universal Journal of Mechanical Engineering, 2(2), 49 - 54. DOI: 10.13189/ujme.2014.020203.